There is a time benefit to leaving a door overtaking it down when you want to paint it, hanging in the body. Also, it is off the floor, and also you will paint both edges and sides in the same time that is same. You will need to prop the door open for for a long period period if you are using oil paint, nevertheless. You run the chance of acquiring sags and drips in your paint-job in the event the door is vertical. You get results that are better by laying it flat and getting it down. Doing so enables brush marks to level out.
Tap out the hinge pins using a hammer and screwdriver and take down the door. Remove the hinges, door knob, any and dead-bolt other components on the door using a screwdriver.
Lay the door on a pair of saw-horses in a guarded location. Cover any windows with masking paper and masking tape.
Scrape off any loose paint using a paint scraper. Fill holes and gouges with wood putty. When the putty is dry, sand both sides of the door using a palm sander and 120-grit sandpaper to smooth the complete that is current and prepare it.
One side of the door and all edges with oil-based primer. In the event the door is unfinished, this can be especially important, but the primer aids adhesion of paint, if it’s a complete. When the primer is dry, flip over the door and prime the other aspect.
Start at one end of the door and distribute the coat of paint using a natural-bristle brush. Cover A6-inch part by the end of the do-or, load the brush and utilize paint to a region that is un-painted after which stroke it in to a region that currently continues to be painted. Use a straight movements, and elevate the brush off the area by the end of the stroke. Use this way to to paint all edges and the complete surface.
Let the paint dry till it spread a coat in the same manner, if required, and after that is no lengthier tacky. Before you change the do-or up to to paint the other facet subsequent to the next coat, wait for a T least 24 hrs. When you paint the other facet to expel drips that happen when you distribute paint on the area near the edge paint the edges.
Supply the paint a T least 2-4 to 4-8 hrs to remedy before you attach the components, after implementing the ultimate coat and re-hang it. The paint might adhere to the jamb when the do-or is closed, even if it feels hard to the contact, should you not wait that extended.